How to Replace the Ignition Coil in a Honda Accord Locate the ignition coil. You should find it close to the intake manifold. For engines like the 2.4L and 3.0L, you should find a distributor that houses the Accord ignition coil. When a distributor is present, you need to remove the distributor cap, rotor and cap seal in order to access the ignition coil. Disconnect the wires that connect to the ignition coil. As you remove these, either make a note of which wire relates to which terminal, or wrap masking tape around the wires to mark the relative position. Make sure you replace the wires in the correct position or your car may not start.

Use a screwdriver to remove the screws that secure the ignition coil in place. Then slide the distributor free from the engine.

Mounts on Distributor; Built to strict quality control standards; Direct replacement; 100% factory tested; 3 Hole; 4 Terminals; Commonly referred to as a Ignitor. 1997-2001 Acura EL Ignition Control Module; 1990-1991 Honda Accord Ignition Control Module for Models with 3 Bolt Mount Module; 1997 Honda Accord DX LX. How to Replace the Ignition Coil in a Honda Accord; How to Replace the Ignition Coil on a 1990 Honda Accord; How to Replace the Ignition Coil in a Honda CR-V; How to Replace the. Reattach the negative battery cable, enter the security code for your radio and reset the powertrain control module.

Replace the old ignition coil with the new one. You can use a stock replacement or universal ignition coil, as long as it fits your engine type. Slide the distributor back in place and secure it with the fasteners. If you use a Torque wrench, tighten the retainers to 9 foot pounds (12 Nm).

Connect the wires and reassemble any other parts you removed. Items you will need • Notepad or masking tape • Screwdriver • Accord ignition coil • Torque wrench, optional How to Replace the Ignition Coil on a 1990 Honda Accord Raise the hood on your Accord and then disconnect the negative battery cable from its post using a socket wrench. Wrap the lead terminal at the end of the cable with electrical tape completely. Push the negative cable down onto the side of the battery to assure it won’t accidentally make contact with the battery during the repair. Locate the distributor cap mounted on the Accord’s engine by following any one of the spark plug wires away from the engine to its connecting point.

Do not disconnect any of the spark plug wires from the distributor cap; you don’t have to for this repair. Draw a line on the left and right side of the two screws holding the distributor cap in place with white correction fluid. The lines will help you align the cap back into its original position once you’re ready to reinstall it. Remove the two screws holding the distributor cap with a Phillips screwdriver and then place both of the screws in your pocket. Jija Tu Kala Me Gori Ghani Mp3 Download.

Pull the distributor cap off slowly. Be very careful, because the spark plug wires are still attached to the cap.